by cday (Posted Tue Dec 13, 2016 8:06 pm)
I'm not a Powershell user, but I can say that when NConvert is run in isolation, it isn't possible to use quotes around the input term at the end of the command line when a wildcard is used in that term; you might therefore do a quick test and check if the following input term without quotes runs:
If you report back that it doesn't provide any insight into your issue, I'll delete the post so as not to distract from your issue... Image may be NSFW.
Clik here to view.
Read Main Topic
I'm not a Powershell user, but I can say that when NConvert is run in isolation, it isn't possible to use quotes around the input term at the end of the command line when a wildcard is used in that term; you might therefore do a quick test and check if the following input term without quotes runs:
- Code: Select all
C:\Users\Me\Desktop\Test_folder\*.jpg
If you report back that it doesn't provide any insight into your issue, I'll delete the post so as not to distract from your issue... Image may be NSFW.
Clik here to view.
Read Main Topic
